good luck :rolleyes: :zzz:
you dont need to install the tw engine and its not a source. Just unpack it and run ./targetware from the directory where you unpacked it. but...
nope, that would't work:)
I have a USB mouse and XPs anyway... However if somebody could give me a link to a tutorial or share knowledge on driver programming, I am all...
nevermind, found it. sry to bother.
May I ask for a link to that driver? I bet I once saw one in the forum, but I cannot find it anymore. Thx in advance.
:)zdar
just one Dutch student. The message was a fake...;)
I'm checking forum from time to time. quite busy irl. (I have not been working on anything since Feb/2003) I will send what I have. Expect them...
negative on no export from gmax :nono: convert to quake3 mesh (module downloadable from discreet) and then to almost anything via deep...
i can convert to almost any widespread 3d format. the conversion routine to WB is AFAIK not complete yet :(
seems i finally managed to post all four. yes ;) , Blenheim Mk. IV :D
...
next two pictures, second try :) :mad:
Separate names with a comma.